R2 JDM Module (With ICP)
(Required jumpers shown in
This guide shows the JDM with J2 and two long jumpers that are only needed
for in circuit programming (which the MIDIbox no longer uses).
Leaving off the J2 connector makes it much easier to get the PIC in and out of the socket.
First install your jumpers:
(locations shown in Red)
As you can see with some of the resistor and jumpers, they won't go in
easily after the sockets are installed:
Changes from V2 PCB:
Some small trace/component moves for better routing
Green LPI solder mask
HASL pad plating
White topside legend silkscreen
For complete technical info and instructions see www.midibox.org